saulowan
Level 1 (4 points)
Audio

Q: Can't hear playback when recording in punch mode

Fellows,

When I try to record (audio) over another take, I can't hear the playback in order to record right on the point, pre listenin' what is before. This occurs in "Create Take Folder" mode, "Replace" and all modes. Auto Input Monitoring, Allow Quick Punch-In are signed, with ou without Cycle, always the the same.

The interface is a DIGI 003, Logic Pro X 10.2.4, Yosemite OS X 10.10.5

What may I do?

Tks,

Saulo

iMac, OS X Yosemite (10.10.3)

Posted on Sep 22, 2016 11:54 AM

Close
saulowan

Q: Can't hear playback when recording in punch mode

  • All replies
  • Helpful answers

  • by Indyuser,

    Indyuser Indyuser Sep 22, 2016 11:59 AM in response to saulowan
    Level 4 (2,245 points)
    Audio
    Sep 22, 2016 11:59 AM in response to saulowan

    Make sure software monitoring is on so when you press play without autopunch you hear it.

    Then once the above is confirmed working. Make sure ato input monitoring is enabled.

    Then when you press record you should hear the track until you reach the auto punch in point then you will hear you live audio During the punch cycle

  • by Indyuser,

    Indyuser Indyuser Sep 22, 2016 12:04 PM in response to saulowan
    Level 4 (2,245 points)
    Audio
    Sep 22, 2016 12:04 PM in response to saulowan

    Also make sure you are doing software monitoring and not hardware monitoring