Unlock iPhone connect to iTunes
unlock iPhone factory reset
iPhone 6s Plus, iOS 10.1
Question marked as
Best reply
Forget your Passcode
If you forgot the passcode for your iPhone, iPad, or iPod touch, or your device is disabled - Apple
If the above doesn’t work for you, then:
Follow these steps to place your iOS device into recovery mode. If your iOS device is already in recovery mode, you can proceed immediately to step 6. 1. Disconnect the USB cable from the iPhone, iPad, or iPod touch and leave one end of the cable connected to your computer's USB port. 2. Turn off the device: Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider. Wait for the device to turn off. * If you cannot turn off the device using the slider, press and hold the Sleep/Wake and Home buttons at the same time. When the device turns off, release the Sleep/Wake and Home buttons. 3. While pressing and holding the Home button, reconnect the USB cable to the device. The device should turn on. Note: If you see the battery charge warning, let the device charge for at least ten minutes, and then start with step 2 again. 4. Continue holding the Home button until you see the "Connect to iTunes" screen. When this screen appears you can release the Home button: 5. If necessary, open iTunes. You should see the following "recovery mode" alert: 6. Use iTunes to restore the device. |
If you don't see the "Connect to iTunes" screen, try these steps again. If you see the "Connect to iTunes" screen but the device does not appear in iTunes, see this article and its related links.
Forgotten Restrictions Passcode Help
iPad,iPod,iPod Touch Recovery Mode
About Restrictions (parental controls) on iPhone, iPad, and iPod touch - Apple Support
You will need to restore your device as New to remove a Restrictions passcode. Go through the normal process to restore your device, but when you see the options to restore as New or from a backup, be sure to choose New. You can restore from a backup only if you have one from BEFORE you set the restrictions passcode.