Looks like no one’s replied in a while. To start the conversation again, simply ask a new question.

Question:

Question: iPod mini (2nd Gen) click wheel pinout diagram

I am looking to find a pinout diagram for the click wheel connector on my iPod mini (2nd Generation). I am trying to diagnose the connector on the motherboard so that I can re-solder it. The motherboard is otherwise functional, I can even play music off of it (using the headphone extension with the control pad on the end as the play and pause). I simply need to re-solder the connector and I will be good to go. I have confirmed that the click wheel is working by using my other motherboard. This other board is basically shot, but still works well enough to enter diagnostic mode and run component tests. The click wheel test came up clean. I have also confirmed that the lock switch is not the issue. If anyone can point me in the direction of a pinout diagram, that would be greatly appreciated. Thank you in advance.

iPod Mini-OTHER, Other OS

Posted on

Reply

Page content loaded

There are no replies.
User profile for user: limmers2015

Question: iPod mini (2nd Gen) click wheel pinout diagram