Installing Agfa Duoscan T1200 scanner with latest OS X (10.4.8)
Does anyone know if it is possible to install my Agfa Duoscan T1200 scanner in my G4 without causing much trouble?
My G4 has a Ultra SCSI card installed. When I check the contents of my PCI Cards it says that I have ADPT,2930CU installed. I am assuming that is the Adaptec 2930 SCSI card.
When I went to download the latest driver for the Duoscan at
http://www.agfa.com/digicamscannerdrivers/index.html
there is a section that says: "Not every scanner supported!" and it says that Mac OS X 10.3 does not support the Duoscan T1200. On that site I was able to download the driver, but I don't want to install it if it will cause problems.
If I don't use FotoLook, but instead I use TWAIN from Photoshop 7.0.1, will it work?
Was anyone successful at all with this, or should I buy another scanner? I hate to do that, as this scanner works very well.
My G4 has a Ultra SCSI card installed. When I check the contents of my PCI Cards it says that I have ADPT,2930CU installed. I am assuming that is the Adaptec 2930 SCSI card.
When I went to download the latest driver for the Duoscan at
http://www.agfa.com/digicamscannerdrivers/index.html
there is a section that says: "Not every scanner supported!" and it says that Mac OS X 10.3 does not support the Duoscan T1200. On that site I was able to download the driver, but I don't want to install it if it will cause problems.
If I don't use FotoLook, but instead I use TWAIN from Photoshop 7.0.1, will it work?
Was anyone successful at all with this, or should I buy another scanner? I hate to do that, as this scanner works very well.
PowerPC G4, Mac OS X (10.4.8)