MIDI note input appears 1 octave lower when controller pads are hit
I can't figure this out and I've wasted 5 hours today trying to correct it....
I have recently noticed that midi input from my padKontrol is being transposed down 1 octave (ie I hit an A2, it appears and sounds in my midi applications as A1). This does not occur with midi data that comes direct from my Axiom 61 keyboard; however, it does happen with another device (MV8000) I have that uses the Axiom's Midi IN interface. I hit a pad on the Mv that is assigned to A2, it shows up as A1 in the Logic transport. In Battery it will trigger the cell assigned to A1 instead of A2.
I'm perplexed because it is happening with two different devices on two different interfaces, yet the Axiom doesn't do it on its own ouput, but it does occur on the data received at the midi in on its interface. Doesn't make sense and it occurs both in Logic and Battery. I'm thinking its an AMS/Core Midi issue since hte padKontrol is truly plugnd play (did not have to install drivers), but I dont have clue on how to get AMS to act right. I couldn't find another applicable forum to post this so I am asking here since Logic is the closest subject to my issue.
Anybody have any ideas?
I have recently noticed that midi input from my padKontrol is being transposed down 1 octave (ie I hit an A2, it appears and sounds in my midi applications as A1). This does not occur with midi data that comes direct from my Axiom 61 keyboard; however, it does happen with another device (MV8000) I have that uses the Axiom's Midi IN interface. I hit a pad on the Mv that is assigned to A2, it shows up as A1 in the Logic transport. In Battery it will trigger the cell assigned to A1 instead of A2.
I'm perplexed because it is happening with two different devices on two different interfaces, yet the Axiom doesn't do it on its own ouput, but it does occur on the data received at the midi in on its interface. Doesn't make sense and it occurs both in Logic and Battery. I'm thinking its an AMS/Core Midi issue since hte padKontrol is truly plugnd play (did not have to install drivers), but I dont have clue on how to get AMS to act right. I couldn't find another applicable forum to post this so I am asking here since Logic is the closest subject to my issue.
Anybody have any ideas?
PowerMac G4 Dual 1Ghz Jaguar 10.2.8, Mac OS X (10.4), PowerBook 17" 10.4
