Apogee AD 16X and Logic Pro 8 Inputs not available

How are you connecting your AD16X to your computer - X-Firewire or a Symphony card?

have you installed the latest software form apogee?

Did you recently buy the X-FireWire card? When they shipped, they were set up for the Rosetta 800 and therefore Firemix only showed 8 inputs with an AD 16X.

Updating to the latest firmware was required for Rev. E cards (two FW ports). I think the latest version is 3.4 - so install the latest updater at Apogee's site.

I have Apogee DA/AD 16x, the DA 16x shows 00.00 on starting, unable to reset it with power & setup buttons, it seems to have worked for a brief while during setup and Maestro was able to recognize it, but not any more. My AD 16x is working just fine, it's seen on the Maestro. The AD/DA are hooked to a PCIe 64 & all drivers were updated prior to installation.

Any amount of permutation combination of buttons is not making any difference, any suggestions, is this a hardware issue?

Is your clock source set to WC or Input? Have you tried switching between Internal to Input and back again?

I'm having the same issue right now. For some reason with my symphony system (2 DA16x's and 1 AD16x) - when I power them on, the DA16x that's connected to the computer shows up on internal workclock working fine, but the other two units are stuck on WC at a sample rate of 00.00. What is going on?

If you've tried resetting, and flipping internal/WC you should call Apogee at 310-584-9394.
I could imagine that a bad firmware upgrade or the reflash via MIDI process could cause this problem (did you attempt this recently?) but not to two units at the same time. Have you tried disconnecting everything to see that they work standalone with internal clock selected?

Anyway, rather than me guessing, give Apogee a call - they'll figure it out, I'm sure.

Please post back with the answer in case someone else has the same problem.