Audio MIDI setup not recognising my Miditech Audiolink III audio interface (does not require driver)

Question

Level 1

8 points

Audio MIDI setup not recognising my Miditech Audiolink III audio interface (does not require driver)

I recently purchased the Audiolink III and bought a 5 pin midi cable to 3 pin xlr to connect my keyboard with midi, the interface seems to recognise that there is a connection because the light is on and responds to me pushing keys down on the keyboard. However, on my Mac’s Audio Midi setup it does not recognise the keyboard, does the Audiolink III not work with midi. My Mac recognises the audio interface as seen below, but when I go to the Midi studio its blank.

Any suggestions to get my keyboard to work on Logic Pro X would be great thanks

MacBook Pro 13″, macOS 10.15

Posted on Aug 22, 2020 6:10 AM

Answer 1

Wilddrums

Level 5

4,306 points

Aug 22, 2020 12:37 PM in response to Dmorg7

As far as I know the Audiolink is an Audio interface only. Not MIDI.

WD

Answer 2

Thyss_81

Level 1

89 points

Aug 22, 2020 12:23 PM in response to Dmorg7

Hi,

In midi studio you can try to add a device with the + button. Then you can create a midi device('s) where you also can draw cables from one output to another device input. Also make sure the in/out have the same sample ate etc.

Hope you can get a litter further.

Grtz

Answer 3

Thyss_81

Level 1

89 points

Aug 22, 2020 12:52 PM in response to Wilddrums

Never doubted Wilddrums but, I checked the interface and your right (as always 😜). There are no midi in/outs on the interface. So I wonder... MMm it's difficult 🤔

Grtz