Stabilizing on a Multicam - Double-clicking trick not working

Hello,

I'm trying to stabilize a section on a multicam clip, and did the trick you folks sent - put the playhead on the area where you want to stabilize and then this will open the Angle Editor right at the place you want to stabilize.

Not working. It always goes to the same position inside the Angle Editor, far away from where it should be.

My timeline has several multicam clips (3 takes from the same scene, recorded with 2 cameras each).

Does this trick work with only one multicam in the timeline?

Any assistance will be very welcomed.

Thanks in advance Community!