Hi everyone,
I purchased a Mac Studio M2 2 days ago, however it doesn't connect to my 10GbE network (other devices work without problems), it can't receive the DHCP IP (and even putting it static doesn't work)...
Has anyone had this problem? how can I solve it?
Thank you very much.
Luca
Mac Studio, macOS 14.0
The Mac Studio is one of the first Macs that does NOT support speeds under 1 Gigabit/sec, or allow the use of cables that have only TWO pairs of wires. All Ethernet cables going to the Mac Studio must have four pairs of wires, terminated correctly.
if your network is not up to at least that standard, you will not be able to make any Ethernet connection, because 100 M bits/sec baseband is NOT supported. At all.
Hi Luca,
Are you running any VPN, Anti-Virus, or Cleaning apps?
Convert the following System Preferences to System Settings...
Make a New Location, Using network locations in Mac OS X ...
System Preferences>Network, top of window>Locations>Edit Locations, little plus icon, give it a name.
System Preferences>Network, click on the little gear at the bottom next to the + & - icons, (unlock lock first if locked), choose Set Service Order.
The interface that connects to the Internet should be dragged to the top of the list.
Sys Prefs>Network>highlight the Interface you're using>Advanced>TCP/IP>Configure IPv4: Using DHCP.
If using Wifi, instead of joining your Network from the list, click the WiFi icon at the top, and click join other network. Fill in everything as needed.
System Preferences>Network>choose interface>Advanced>Proxies Tab, make sure none are set, like for HTTP & HTTPS.
System Preferences>Network, unlock the lock if need be, highlight the Interface you use to connect to Internet, click on the advanced button, click on the DNS tab, click on the little plus icon, then add these numbers...
8.8.8.8
8.8.4.4
1.1.1.1
9.9.9.9
Apply.
Thanks everyone for the replies
the cable is ok as sometimes it connects and takes the IP and all the other parameters, after a while that the PC is NOT used however it seems to no longer connect, as if the port went into standby... I attach other screenshots
Searching the community I notice that others have these problems.
Thank you very much
Enabling AVB/EAV is used ONLY when connecting high speed Video-ONLY feeds. That settings turns OFF re-transmit after error.
Other uses can cause packet loss without any attempt at recovery, which if NOT 100 percent Video, is NOT acceptable for ordinary data.
Mac Studio & 10Gbe... missing ip
