THE PROMPT TO SCAN THE SCREEN TO PAIR THE WATCH IS NOT WORKING BUT I HAVE MY WATCH LISTED. I HAD TO RESET MY IPHONE LAST WEEKEND AND THEN ONCE I HAD ACCESS TO MY PHONE, NOW MY WATCH STOPPED PAIRING.
Apple Watch Series 3
If the "I" icon isn't informative enough and doesn't explain the issue there a few other things you can do: try restarting both devices, unpair and re-pair your apple watch or reset your watch.
Resetting Apple Watch erases all content and settings. But if you still decide to go with this solution, here is how to do it:
On your Apple Watch, go to Settings > General > Reset > Erase All Content and Settings.
Confirm to reset your watch.
Set Up Your Apple Watch Again:
Follow the instructions to pair your Apple Watch with your iPhone as a new watch.
hope this helps!
The “activity” icon (to the left of the the watch face on the screenshot) indicates that the Apple Watch is not properly communicating with the iPhone. You should instead see a check mark.
Tap the “i” icon (to the right) and unpair the Apple Watch. Reboot the iPhone and pair the watch again.
I am resetting the watch now. It's been spinning for about an hour. Not sure how long this take. I pushed the roller button plus the side button until the apple icon was visible, then pressed the side button again to reset. Its been resetting for awhile. Hope this works.
I can't access anything on the watch since it's in pairing mode.
UNDER "MY WATCHES" MY WATCH IS LISTED, HOWEVER IT WONT PAIR AFTER RESETTING
