Audio crackling using apple 9 and apogee ensemble

After further examination, i noticed that my last recorded audio fiile with clicks was done the morning of the 13th.

That evening i intalled the update.

...testing in progress...

preparing "spoke too soon" list for update.

Did I mention that my cousin still works on that #@!forsakken place?

and loves it!?!

Unable to find obnoxious pops and clicks after recording 10 min of audio and listening back.

ink still drying on "spoke too soon" list

Thank God!

It really works for me as well! No pops/clicks after 10.8.3 even at buffer size 64. I'm sooooo happy!

Have anyone tried Ensemble with Mavericks? Yes I know Apogee claim compatibillity with Mavericks but so they did with Lion and Mt Lion...

YES, and it woks fine, or should I say: it works with the same problems as it did with ML?!?

because the problem togehter with iTunes is still the same. So when you run iTunes at the same time just to hear music or to do playalongs with a loaded logic pro x (or logic pro 9) you will get all approx 10 minutes a very strange audio-behavior. It sounds for a couple of minutes that the audio doubles and repeads very loud. I spend some days with testing and did a complete new installation with ML and Maverics and only Logic Pro X (or 9) togehter with the apple support, but it is still there. Did anyone of you get the same problem? So just a clean installation of ML or Maverics with Logic Pro (9 or X doesn't matter) Load a small project in Logic and run in another window itunes. After a while, (1. time it takes about 20 minutes) you will got a very strange audio problem and it does not matter which kind of audio it is. I tried to use VLC instead, but it produces exactly the same behavior.

Would be great if someone could test this on his iMAC

Not sure if this will help. The 2 times I got the noise that you describe. 1. I down loaded a demo that when it expired it caused this noise, so that you would know that it expired. 2. When my interface is set for a diffrent sample rate than my DAW.

Hope this helps

thanks stuart35! but unfortunately not. Did not load any Demo at all and sample rate does not matter, tried every combination at the ensemble and found out that my DUET FW produces exactely the same problem after a while. So must be somewhere in the driver, buffer management or interface protocoll i guess

For me it might be very interesting if someone else with a similar configuration will have the same problem because I testet nearly everything to find the reason for this problem.