Hi everyone.
Finally managed to get a 2011 Macbook Pro.
I did an SSD upgrade, but because I wasn't careful enough, I dropped the entire bottom plate screws on the floor. Found them all, but cannot figure out the order. Some are longer than others.
Anyone might have a link where I can actually see which screw goes to which hole?
Will be so helpful!
Thank you so much!
You may seek guidance for placement of screws through use of fix it online pages
where images are shown in place; some also during removal. OWC may have video
of takeapart processes; iFixit has static pages with some images. ~ I'd look into both.
Powerbookmedic has some free 'repair guide' pages & 'identify by serial number' page.
Macbook Pro unibody lower case screw set (image of screws/types) - iFixit
Without knowing the display size and other exact details, some factors such as
screw length between these same year models can vary; but perhaps not much.
You may seek guidance for placement of screws through use of fix it online pages
where images are shown in place; some also during removal. OWC may have video
of takeapart processes; iFixit has static pages with some images. ~ I'd look into both.
Powerbookmedic has some free 'repair guide' pages & 'identify by serial number' page.
Macbook Pro unibody lower case screw set (image of screws/types) - iFixit
Without knowing the display size and other exact details, some factors such as
screw length between these same year models can vary; but perhaps not much.
If you have the clutch cover/hinge facing away from you the three long screws are on the back row near the hinge openings 2, 3, & 4 (the three right most along the back). Shorter screws may all be the same. If not, then the ones without the shoulders go in the back left corner, and the left & right mid sides. The four remaining shoulder screws go along the front. I really don't think it matters much for the short ones as I've seen them mixed up.
Can't figure out the screw order and size in 2011 Macbook Pro. Help
