Getting “weak security “ message, what should I do?

I’m getting a weak security message on my Wi-Fi and I’m afraid some of my sensitive information may be hacked, what can i do . My Wi-Fi is password protected, so why it it considered weak ?

iPad Air 2, iPadOS 14

Posted on Sep 20, 2020 10:09 AM

Reply
Question marked as Top-ranking reply

Posted on Sep 20, 2020 10:15 AM

iPadOS produces these information messages to indicate that the security settings are far from ideal.


This support page will describe the more secure (recommended) settings for WiFi:

Recommended settings for Wi-Fi routers and access points – Apple Support


It is possible that your WiFi Router is too old for you to be able to set more secure settings on the router - so you can either configure the most secure settings that your Router will support, or update your Router for something that provides better security features.

28 replies
Question marked as Top-ranking reply

Sep 20, 2020 10:15 AM in response to Wi-Fiquestions

iPadOS produces these information messages to indicate that the security settings are far from ideal.


This support page will describe the more secure (recommended) settings for WiFi:

Recommended settings for Wi-Fi routers and access points – Apple Support


It is possible that your WiFi Router is too old for you to be able to set more secure settings on the router - so you can either configure the most secure settings that your Router will support, or update your Router for something that provides better security features.

Sep 27, 2020 12:24 AM in response to Strol

Strol wrote:

I’m having this problem and my broadband supplier has sent a new “up to date” router but I’m still getting “weak security” and WPA2 (TKIP) is not considered secure and says about configuring the router to use WPA2(AES) or WPA3. My iMac doesn’t give out this message! Surely this is an iPad issue?


This is not a fault of your iPad - or your WiFi Router - but is an indication that you should improve the security settings of your WiFi network (i.e, WiFi Router and/or WiFi Access Points).


Your iPad is no less secure today than it was prior to the update to iPadOS14. However, your iPad is now better able to [warn] bring to your attention security deficiencies of your WiFi network and iPad settings.


To reiterate my reply to the OP, this support page will describe the more secure (recommended) settings for WiFi:

Recommended settings for Wi-Fi routers and access points – Apple Support


It is possible that your WiFi Router is too old to be (or not capable of being) configured for more secure settings. As such, you can either configure the most secure settings that your Router will support - or replace your Router with something more advanced that provides better security configuration options. 


TKIP (Temporal Key Integrity Protocol) is insecure; TKIP was introduced many years ago to improve the security of the fundamentally broken WEP protocol. Whilst WPA3 is the newest standard, you should aim to use WPA2 as a minimum.

Sep 28, 2020 3:41 PM in response to fawkesy

ISP provided WiFi Routers are principally intended to provide a cheap and generally reliable connection - of the subscriber to the ISPs services. Quite often, the router will provide “adequate” (but not cutting edge) features, including security. In many cases, the subscriber will have no alternative other than to use the ISPs Router.


The “weak security” warnings that are seen by some users, following update to iPadOS14, are the iPad providing warnings that the WiFi security settings are less than ideal - usually because the current security configuration is using an insecure security protocol.


To be abundantly clear, the warning does not imply that your iPad or WiFi Router are broken - or that they are any less secure than they were prior to updating of Apple devices to iOS/iPadOS14; instead, for those that do not necessarily understand the strengths and weaknesses of their iPad and WIFi network security settings, your device now produces visible information about your WiFi security.


If you are genuinely concerned for your security and privacy, you would treat any equipment that you do fully control, such as equipment provided by your ISP, as untrusted. As such, you will ideally provide your own network equipment (that is entirely within your control) upstream of your ISP-provided kit - that includes a firewall. For many, this level of network segregation is either beyond the capabilities of the user - or presents additional cost that the user is not prepared to accept.


There is a half-way position - where at least you can easily apply and use strong WiFi security. A good quality WiFi Router or WiFi Access Point, that supports WPA2/WPA3 is a relatively inexpensive investment. Once added via a wired ethernet connection, you can disable (or simply not use) the WiFi network provided by your ISP-provided Router. Whilst a significant generalisation, your additional Router/AP will provide much stronger security settings, better range and increased local throughput.


In conclusion, I recommend that you purchase and incorporate an additional Router/AP. Any concerns (and security warnings) will evaporate - and your home WiFi network will be technically improved in all respects.



Sep 28, 2020 4:31 PM in response to LotusPilot

I am thinking of adding an extender or whatever if CenturyLink comes back with the news that they do not offer any with WPA2 AES or WPA3. The "customer advocate" I am now in contact with is checking with their tech people. I have no choice with the modem - this is a DSL line and requires their equipment. So, mine works well as far as signal - how would I go about adding another router and how do i find something that will work with a CenturyLink DSL router?

Sep 29, 2020 8:45 AM in response to LotusPilot

Unfortunately, i agree with every word you uttered!


We are paying $45/month for a DSL line which is supposed to give us 20M (and it did that in the beginning), but now shows about 11M and my iPad showed 4.5M in a speed test the other day. The CenturyLink rep said that they no longer offer 20M in my area, only 10M, but he claimed that my install of 20M would still apply. That is a bit questionable to me: if they either added too many customers since to maintain the 20M or changed something in their unit (which is 1/2 mi from our house), then wouldn't all customers be affected? And, adding another router wouldn't change the connection speed, just add the newer security protocol. So, the slow connection would still be present, right?

This thread has been closed by the system or the community team. You may vote for any posts you find helpful, or search the Community for additional answers.

Getting “weak security “ message, what should I do?

Welcome to Apple Support Community
A forum where Apple customers help each other with their products. Get started with your Apple Account.