Speed

I have a time capsule and want to know the maximum speed thru the Ethernet connection

iMac 21.5″, macOS 10.15

Posted on Feb 18, 2022 1:14 PM

Reply
Question marked as Top-ranking reply

Posted on Feb 18, 2022 1:29 PM

Edit.. sorry to jump in over conversation.. there were no replies when I started. Type too slow.


There isn't a single answer to your question.


I am guessing you mean WAN to LAN speed??

Even with that question there are multiple answers..


With Time Capsule (TC) setup as router, and we are talking about Gen4 or Gen5 model then I would expect 400Mbps.. up to maybe 450.. although I have seen higher figures.. the confusion can be caused by the setup.

On IPv4 then put a figure of 400Mbps and any extra is bonus.


But if your ISP supports IPv6 that is entirely different.. IPv6 does not use the NAT router required for IPv4 which is the major cause of slow downs.. and you can get close to the full speed of gigabit.

Of course in real world you will not have all sites using IPv6 so it will slow down again for any site using IPv4.


If you are talking LAN to LAN speed .. then it is a standard gigabit switch chip and you should get very close to gigabit.. usually a figure like 930Mbps. That is including overheads so when you work out MegaBytes from Megabits it will have 10% inefficiency due to packet overhead.. so 90-100MByte/s

5 replies
Question marked as Top-ranking reply

Feb 18, 2022 1:29 PM in response to Markslespaul

Edit.. sorry to jump in over conversation.. there were no replies when I started. Type too slow.


There isn't a single answer to your question.


I am guessing you mean WAN to LAN speed??

Even with that question there are multiple answers..


With Time Capsule (TC) setup as router, and we are talking about Gen4 or Gen5 model then I would expect 400Mbps.. up to maybe 450.. although I have seen higher figures.. the confusion can be caused by the setup.

On IPv4 then put a figure of 400Mbps and any extra is bonus.


But if your ISP supports IPv6 that is entirely different.. IPv6 does not use the NAT router required for IPv4 which is the major cause of slow downs.. and you can get close to the full speed of gigabit.

Of course in real world you will not have all sites using IPv6 so it will slow down again for any site using IPv4.


If you are talking LAN to LAN speed .. then it is a standard gigabit switch chip and you should get very close to gigabit.. usually a figure like 930Mbps. That is including overheads so when you work out MegaBytes from Megabits it will have 10% inefficiency due to packet overhead.. so 90-100MByte/s

Feb 18, 2022 1:23 PM in response to Markslespaul

If the Time Capsule is set up as your router, the maximum speed through Ethernet would be in the 325-350 Mbps range.


If the Time Capsule is not set up as your main router........meaning that it is in "Bridge Mode"........the speed of the Time Capsule might approach 500-600 Mbps.


If the connection from your Internet Service Provider (ISP) is less than this, then the Time Capsule will be limited to the speed that your provider is supplying to you.

Feb 18, 2022 1:30 PM in response to Markslespaul

To what device is the Time Capsule connected? The Android "box"?


If you disconnect the Time Capsule from the "box" and connect your computer directly to the box using an Ethernet cable, what speed do you see?


A defective Ethernet cable will allow a connection, but knock a 1,000 Mbps signal down to 100 Mbps, so check the Ethernet cable connections as well.

This thread has been closed by the system or the community team. You may vote for any posts you find helpful, or search the Community for additional answers.

Speed

Welcome to Apple Support Community
A forum where Apple customers help each other with their products. Get started with your Apple Account.